国产在线观看av专区,三上悠亚性生活视频在线免费观看,日韩 欧美 亚洲中文字幕,97国产精品视频久久,欧美三级在线免费完整版,亚洲高清视频在线不卡,久久久久久久9999久久久,青青碰在线视频免费观看,粉嫩国产av一区二区三区

The plastic granulator adopts a special screw design and different configurations, suitable for the regeneration and color mixing granulation of various plastics such as PP, PE, PS, ABS, PA, PVC, PC, POM, EVA, LCP, PET, PMMA, etc. Today, we will talk about the precautions for using plastic granulators.

Power on operation method:

1. Before starting up, first raise the temperature for about forty to fifty minutes, and then raise the temperature to the point where you can pull the motor triangle belt by hand until it is free. Rotate it in the normal working direction and pull it continuously eight to ten times. Then continue to heat up for about ten minutes, and then turn on the machine, but continue to heat up because normal production requires continuous heat replenishment; Adjust different temperatures based on the properties of plastics.

2. When the plastic granulator is working normally, the machine temperature should remain stable and not fluctuate between high and low temperatures. Near the vent hole, the temperature of the machine head should be maintained at around 200 ℃ (referring to materials C and B).

3. The feeding should be uniform and sufficient. The feeding speed and feeding speed of the machine should be coordinated appropriately. Otherwise, it will affect the quality and yield of particles,

4. When shutting down, the host should be completely powered off. The machine head plug (with wrench) must be removed. Preheat separately before next use

2、 Notes:

1. The plastic granulator should operate in a forward direction to avoid reverse rotation.

2. The granulator should avoid running the cooling machine on an empty stomach. It is necessary to run the hot machine with added materials to avoid sticking to the shaft

3. It is strictly prohibited to enter iron objects and other debris into the feed and vent holes of the granulator. To avoid accidents and impact production

4. Always pay attention to changes in the temperature of the body, and when using a clean touch strip without touching your hands, immediately raise the temperature. Until the note touches hands, it is normal.

5. When the bearing part of the reducer burns or is accompanied by noise, it should be repaired in a timely manner and supplemented with oil.

6. When the bearings at both ends of the main engine bearing room are burned or there is noise, it is necessary to stop the machine for maintenance and add butter. During normal operation, add grease to the bearing housing every 5-6 days.

7. Pay attention to understanding the operating rules of the machine; For example, the temperature and speed of the machine can be adjusted in a timely manner according to the situation.

8. When the machine body is unstable, attention should be paid to checking whether the gap between the coupling devices is too tight, and it should be adjusted in a timely manner to loosen it.